|
INCLUDED with Standard
Installation |
NOT INCLUDED
with Standard Installation |
Mount
the dish to an approved structure at least five feet off the
ground as required by FCC regulations, using HUGHES standard roof,
and/or wall mounting brackets.
Mount to a one-story surface.
|
Complex/custom
installations that may result in additional fees.
- Make sure you discuss any custom work
with your installer before they begin the job.
|
| Install a coaxial
cable jack in the room where the HughesNet System will be located.
Route two exterior RG-6 coaxial cables (each up
to 100 feet in length) from the dish into the house, and to the
coaxial cable jack. |
Custom work
including, but not limited to:
- Moldings or cosmetic hardware to help
hide cables
- Non-penetrating roof, pole, or chimney
mounts
|
|
Provide and install the hardware required to properly ground your
HughesNet System. |
Removal and/or repair of previously mounted equipment (a signed
Waiver of Liability must be included to perform this work). |
| Install the
HughesNet modem and connect it to your PC. |
Mounting to a roof
surface that exceeds one story in height. |
Verify receipt of
satellite signal.
Commission your HughesNet account. |
Non-penetrating
roof mount, pole mount, or chimney mount. |